Finding Clear-Cut Solutions For Water Heater Installation

Simple Tips To Help You Deal With Plumbing Issues

This is going to be one of the best resources available for you to learn more about plumbing. There might be a lot of resources available both on and offline, however we have gathered the best information in this article and sorted out the obvious or incorrect advice that you may find elsewhere.

Do not put cooking oils, fat, or grease, down your drain. These fats cause clogs by solidifying in pipes. To properly dispose of fats, put them in a bowl with a lid that you can dispose of. Once it gets hard, throw it in the trash or compost bin.

Do not use the liquid cleaning supplies that are designed to clear clogs. These cleaners are harmful and can damage your pipes as they clear the clog. Instead of using damaging liquids, use a plunger or a plumbing snake. These are much more effective and will not harm pipes.

If your drain in any device is taking longer to drain water, then you may need to have your pipes professionally cleaned depending on the severity of the circumstances. Before you do this, there are several different products you can try. However, some of them are professional strength and all products should be used with caution.

Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.

Believe it or not, it is not a very good idea to use a plunger if your toilet is clogged. Plungers just push whatever is stuck deeper into the drain. Instead, it is a better idea to use a closet auger. It will do a better job and is affordable.

Do you have a frozen drainpipe? You can use a garden hose to thaw it out. First of all, remove the trap from the drainpipe and insert the hose until it will not go any further. While lifting up the other end of the hose, pour hot water down it. Keep pouring hot water down the hose until the drainpipe thaws. To save time with cleanup, keep a bucket underneath to catch the water that Plumber overflows.

Some people have problems with their plumbing system in that the pipes sweat and drip condensation. You do not have to hire a plumber to take care of this nuisance. You can purchase self-adhesive drip tape from your local hardware store. This drip tape will insulate your "sweating" pipes which are dripping with moisture built up from condensation. To make sure the tape sticks firmly, dry the pipe thoroughly before applying the tape.

Cover pipes that are outside or in cool areas. Use heat tape to make sure that the pipes are completely covered and insulated. This will prevent frozen pipes in the winter, which can be an expensive problem. Check outdoor pipes for other problems such as leaks and cracks which are better to catch early.

To be successful in any plumbing project, make sure you turn the water off before you start unscrewing pipes. This tip might actually sound insulting, but you are probably getting caught up in having the right tools and parts and being dressed right. Double check that there is not a splash waiting for you. Then triple and quadruple check.

Frozen pipes can lead to many problems, most of them expensive to fix. So you want to avoid that at all costs. To avoid frozen pipes, make sure the temperature in your home never drops below 55 degrees. Look for any air leaks around your pipes and make sure they're sealed up.

Every now and then, you should pour a large bucket of water down your basement floor drain. This will help to keep the trap seal full and prevent certain gases from coming up into your home. Also, be sure that you have your floor drain checked by a professional every few years.

If you own property where the temperature gets below freezing for an extended amount of time each year, you should make sure that pipes located in unheated areas, such as crawl spaces and garages, are insulated. Pipes that are exposed to the outside elements or those that are prone to freezing, should be protected by heat tape or thermostat-controlled heat cables to prevent them from freezing.

In conclusion, there is a lot to know about plumbing and not all of the advice available is useful. Ideally, this article either provided you with new knowledge or it allowed you to solidify current knowledge. Use this great information today and you will be set up for success with any plumbing project.

How to get a decent plumber without going round the U-bend

Finding the valves

You can also search for reputable tradesmen in England and Wales via the Association of Plumbing and Heating Contractors (APHC) and in Scotland and Northern Ireland through SNIPEF.

John Thompson, the chief executive of the APHC, says there really is no need to stick with the first available plumber that you stumble on.

"If you feel pressurised into accepting work without a full explanation, have the confidence to question or get a second opinion. Also check if the tradesmen has the right credentials to work on your appliances," he says.

Mind you, if water is pouring, or even just dripping from the ceiling, you will need to try and isolate the problems to minimise damage before the plumber arrives.

For major leaks, turn off the water supply at the main stop tap, usually in the kitchen. You might need to resort to turning off the water company tap at the boundary of the property. Older ones may also turn off your neighbour's supply.

Smaller internal leaks can be stopped using local isolation valves - usually next to the appliance or tap concerned. These may be less familiar to older consumers as they take the form of levers or are just turned with a screwdriver.

On a combi boiler the isolation valve will be located underneath the boiler.

Ian Ruddick

Image caption,

Turning the thermostat up too suddenly can push your boiler over the edge, says Ian Puddick

Lagging

Ian Puddick is the founder of the London Boiler Company. His team is well used to being called out to replace worn out boilers which give up the ghost when they are pushed too hard.

"What happens is that all of a sudden people turn the thermostat up, but this pushes your boiler over the edge," he says.

"Also where you have tanks in the loft, check the little one to see that it's full of water. These can work with little in them for years, but when you turn the temperature up it drives the system a bit harder and then it stops."

Mr Puddick also has a helpful tip for avoiding a big freeze in your loft.

"Once you have checked all your pipes and tanks are lagged, protected and covered, check underneath the water tank. If there's some insulation there just pull it out and leave that area clear so heat can rise and protect the tank."

Emergency repairs are costly. So to avoid being fleeced by an opportunist plumber, it's worth getting your pipes and systems checked and serviced by a reputable engineer before temperatures drop once again.